Your Ad Here




COUNTERSINK BIT

A combination drill bit used to set screws flush to or below the surface of the wood.

CORDLESS REVERSIBLE SCREWDRIVER

Light-weight, battery-operated screwdriver. Useful for small assembly projects.

COPPER TUBE DEBURRER

Removes burrs and debris from the exterior of copper pipe in preparation for soldering.

COPPER FITTING BRUSH

Deburrs and cleans debris from the interior surface of copper pipe and fittings.

COPING SAW

A fine-toothed, thin-bladed sawblade mounted in a C-shaped frame used to cut precise outlines in wood.

CONTINUITY TESTER

An instrument that tells whether a device is capable of carrying electricity.

COMPASS (SCRIBING)

An adjustable tool used to transfer contours from one surface to another with a pin on one leg and pencil clamp on the other.

COMBINATION WRENCH

A wrench with an open and boxed end. The boxed end provides more control and less slippage.

COMBINATION SQUARE

A layout tool with a sliding handle used for marking lines at both 90 and 45 degrees.

COMBS

Made of plastic or rubber, used to apply decorative finishes to surfaces.

COLD CHISEL

A steel chisel with a tempered edge used for cutting steel and for removing ceramic tile. Available with rubber safety handles.

CLOSET AUGER

An auger designed specifically to remove clogs in toilets without damaging the toilet.

CLAW HAMMER

A hammer that comes in various weights with a face for driving nails and curved tines on the other for prying and nail removal.

CIRCULAR SAW

A hand power tool primarily used for crosscutting and ripping wood materials to length and width.

CIRCULAR LEVEL

Used to determine level on horizontal surfaces.

CIRCUIT TESTER (NEON)

Used to test for the presence of electricity in a circuit.

CHALK LINE

A chalk-filled container used to mark long straight lines for cutting or alignment.
Also used as plumb bob.

CAULKING GUN

A tool used to hold tubes of caulking or adhesives for applications such as sealing seams and bonding materials.

CAT’S PAW (PRY BAR)

A steel bar used to remove nails or to pry pieces apart.

CARPENTER’S PENCIL

A large flat pencil with a wide lead used for marking.

CARPENTER’S LEVEL

A straightedge with leveling bubbles available in several lengths. Used to determine horizontal and vertical planes.

CARBIDE GRIT ROD SAW

A hand tool used for cutting ceramic tile.

CARBIDE DRILL BIT (ADJUSTABLE)

An adjustable carbide drill bit used for cutting precise access holes in ceramic tiles.

CABINET TEMPLATE

Used to mark holes for attaching cabinet hardware.

C-CLAMP

A screw-operated clamping device that comes in various sizes.

No comments: